YShield M6-32 is a self-adhesive shielding plate against magnetic fields from electric current and against static magnetic fields. YShield M6-32 is a product for shielding against electromagnetic fields.

YShield M6-32 is a magnetic field shielding plate for shielding low-frequency magnetic fields. The M6-32 magnetic field shielding plate is protected on both sides by a film.

The YShield M6-32 magnetic field shielding plate is suitable for small areas in a domestic environment as well as for large areas in construction, commerce or industry. In addition, there are various application possibilities in cars, electric vehicles, vans, motorhomes, mobile homes and vans. Protection against the magnetic field emitted by electric car batteries.

Technical data of the YShield M6-32 magnetic field shielding plate:

• Dimensions: 29 x 21 cm (shielding surface); 31 x 23 cm (total product)
• Thickness: 0.6 mm
• The top side is made of high-performance glue. The bottom side is made of aluminum foil.
• Magnetic field attenuation (three-phase 50 Hz): single layer 20 dB (89.4%), two-layer 26 dB (94.8%), three-layer 30 dB (96.9%), four-layer 33 dB (97.7%)
• Magnetic field attenuation (single-phase 50 Hz): single layer 18 dB (87%), two-layer 23 dB (93.1%), three-layer 27 dB (95.4%), four-layer 29 dB (96.6%)
• Magnetic field attenuation (static): direct current, earth's magnetic field, permanent magnets are shielded in the range of 15% (single layer) to 58% (four-layer)
• Minimum bending radius: 20 cm

Implementation Installation of the YShield M6-32 magnetic shielding plate:

• Mandatory grounding, use the grounding kit sold separately and the correct length of GSX conductive tape (also sold separately), each M6-32 plate must be glued on the aluminum side with the GSX conductive tape, all strips of GSX conductive tape must be connected to the grounding kit. In the case of large areas, provide several grounding points.
• The YShield M6-32 plate can be cut with scissors. Be careful, the cut edges are very sharp: use protective gloves when handling the cut plates.
• For effective magnetic field shielding, the shielding surface of each M6-32 plate must overlap by at least 2 cm on all sides. When installing multiple layers: always install the plates in an offset position (the full surface must cover the overlap on the layer below).

Miscellaneous information on the YShield M6-32 magnetic field shielding plate:

• The YShield M6-32 self-adhesive magnetic field shielding plate is made of 6 layers of metal glued together.
• The YShield M6-32 magnetic field shielding plate is made in Germany.
• Effectiveness tested and approved by an independent electromagnetic wave measuring laboratory.
• This product also protects against low frequency electric field and high frequency electromagnetic radiation up to 40 GHz.